The proportion of steel shot and steel grit in the shot blasting process

The shot blasting process after casting requires the ratio of steel grit and steel shot. The ratio of the matching needs to be understood and recognized by everyone. Today, the steel shot manufacturer will introduce you to this detail, which is convenient for everyone in the shot blasting. I don’t know how to match. Liaoning Steel Wire Cut Shot

    The steel grit manufacturer found that with the increase of time, part of the hook type shot blasting machine and the sealing tape were crushed, and the hook type shot blasting machine was not repaired in time, resulting in a large number of shot blasting machines in use. The steel grit flew out along the gap in the hook type shot blasting machine chamber. It causes more waste than necessary, and the phenomenon of steel shot and steel grit flying out and hurting people. How to avoid causing this phenomenon?

    1. Reasonably arrange the tooling of the shot blasting machine to project the workpiece, so that the steel sand of the shot blasting machine is projected on the surface of the workpiece, so as to reduce the damage caused by the steel sand impacting on the protective plate of the hook type shot blasting machine room.

    2. The maintenance worker of the hook type shot blasting machine should always check the usage of the shot blasting machine. If the shot blasting machine room body is damaged, they should promptly replace the sealing strip of the shot blasting machine room body guard to avoid greater waste.

    3. Reasonably match the ratio of steel shot and steel grit to increase the fluidity of steel shot and steel grit, reduce the residence time of shot blasting machine steel grit in the shot blasting machine chamber, and form a good circulation process.

    The ratio of steel shot to steel grit must be determined through these steps, so as to have better efficiency.